An Improved Anchorage System for L-Shaped FRP Composites to Enhance the Seismic Response of Beam-Column Joints in a Low-Strength Substandard Reinforced Concrete (RC) Frame

Reinforced concrete buildings are prone to collapse during seismic events due to the brittle shear failure of non-seismic beam-column joints (BCJ). In this study, two one-third scale reinforced concrete (RC) frames incorporating various non-seismic details were tested under lateral cyclic loading. One of the RC frames was used as control, while the other was strengthened using externally bonded carbon-fiber-reinforced polymer (CFRP) sheets in a L-Shaped configuration with particular attention to anchorage to evade debonding. For the strengthening process, L-shaped CFRP sheets were bonded to the inner face of columns, extended on beams both above and below the joint up to a hinge length. To avert debonding, the L-shaped CFRP sheets were fully wrapped with CFRP sheets around the column, both near the joint and at the end of the sheet. The sheets were also wrapped around the beam, through two slots in the slab that were adjacent to the beam-column interface and at the far end of the sheet. Test results confirmed that the installation of CFRP sheets in an L-shaped configuration altered the brittle-shear failure mechanism of the beam-column joints to a ductile failure by repositioning the hinges away from the columns. Additionally, the proposed anchorage method successfully eradicated the debonding and peel-off of the CFRP sheets. Moreover, strengthening with the CFRP sheets in the L-shaped configuration enhanced the strength and ductility of the RC frame by 45% and 43%, respectively. According to the findings of this study, the application of L-shaped CFRP sheets proved effective in strengthening RC frame structures.