Influence of Non-Invasive Zirconium Oxide Surface Treatment on Phase Changes
Kinga Regulska, Bartłomiej Januszewicz, Anna Jędrzejczak, Leszek Klimek- Materials Science (miscellaneous)
- Ceramics and Composites
The aim of the research was to find a zirconia treatment method that would reduce or minimize the transformation from the tetragonal phase to the monoclinic phase. Background: Yttria-stabilized zirconia is increasingly chosen for the base of permanent prosthetic restorations. To achieve a good bond between the prosthetic cup and the veneer material, the material must be treated to achieve surface development. This is a mechanical process, during which an unfavorable transformation from the tetragonal into the monoclinic phase takes place, which leads to the weakening of the internal structure of zirconium dioxide, and later damages the prosthetic restoration. Methods: The tested material consisted of cylindrical samples of 3Y-TZP CeramillZi zirconium oxide, which were sintered after cutting out from the block. After sintering, the samples were subjected to the following types of processing: laser structuring, chemical etching and plasma etching. After the surface treatments, the samples were subjected to diffraction tests to determine the phase composition. Next, the wettability was tested to determine the surface free energy. Results: On the basis of the conducted tests, it was noticed that the applied treatments caused a phase transformation from the tetragonal to the monoclinic phase. After the process of chemical etching, the range of the monoclinic phase for the sample was 5%; after plasma etching, it was 8%, and after laser structuring, it was 2%. In addition, post-surface free energy studies have shown that zirconia is wetted better with an apolar than a polar liquid. Conclusions: The obtained results indicate that the transformation was minimized with the treatments we applied; that is why they are called non-invasive methods. According to the literature data, depending on the parameters of the sandblasting process, the percentage of the monoclinic phase in the treated surfaces ranges from 22% to 52%, which confirms the above-mentioned conclusion.